User Manual

Port 1 / Port 2
- CAMERA / PORT 1
Input from camera sync terminal, external trigger button, Flash Confirmation Cable, or
other device
Output to camera motor drive, flash, or other device
- FLASH / PORT 2 = Output to flash, camera motor drive, or other device
Status LED
Displays the following information:
- Blinking every few seconds = power on, ready for trigger
- Blinking in sync with trigger = normal triggering
- Steady =
continuously triggered from radio, hot shoe, or PORT 1
performing delay or contact time
- Once every two seconds = performing Intervalometer or Multi-pop function
- Dark = power off or poor battery condition
GETTING STARTED
Please pay attention to the following safety warnings:
- Operating temperature: above -15¡ C (5¡ F) and below 50¡ C (120¡ F)
- Storage temperature, without batteries: above -30¡ C (-22¡ F) and below 85¡ C (185¡
F)
- Remove batteries during storage.
- Battery Requirements: IEC:LR6 (AA) Size
- Do not remove instrument covers during operation.
- Do not operate the device in the presence of flammable gases or fumes. Operation of
any electrical instrument in such an environment constitutes a definite safety hazard.
- There are no user serviceable parts inside the MultiMAX II. Do not install substitute
parts or perform any unauthorized modification of the instrument. Refer servicing only to
qualified and authorized personnel.
Red LED’s are used for dim light application and do not indicate a hazardous status.
- The MultiMAX II is an accessory device for cameras and flashes.
Do not use this product in a manner not specified in documentation.
Battery Information
CAUTION: Turn OFF your equipment (PocketWizard units, electronic flash units,
cameras, etc.) before making connections or changing batteries.
Install 2 fresh AA (IEC:LR6) batteries into the MultiMAX II. Make sure to note proper