User's Manual
WARNING
Changes or modications to this unit not expressly approved by the party responsible
for compliance could void the user’s authority to operate this equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy, and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and the receiver.
3. Consult the dealer or an experienced radio or television technician for help.
This device complies with Part 15 of the FCC rules and also with RSS-210 of Industry Canada. Operation is subject to
the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any
interference received, including interference that may cause undesired operation.
MiniTT1 for Canon FCC ID Number: KDS-PW3-004
FlexTT5 for Canon FCC ID Number: KDS-PW3-005
MiniTT1 for Canon CANADA IC: 2170A-PW3004
FlexTT5 for Canon CANADA IC: 2170A-PW3005
MiniTT1 for Nikon FCC ID Number: KDS-PW3-007
FlexTT5 for Nikon FCC ID Number: KDS-PW3-008
MiniTT1 for Nikon CANADA IC: 2170A-PW3007
FlexTT5 for Nikon CANADA IC: 2170A-PW3008
The FCC wants you to know:
LPF680v1.8 July 2010
MAKE IT POSSIBLE
™