Instruction Manual

8
Chapter 3: Getting Started
Product Service 1-800-522-7658, International 816-333-8811
DO NOT RETURN GOODS WITHOUT THE
PRIOR AUTHORIZATION OF LABCONCO.
UNAUTHORIZED RETURNS WILL NOT BE
ACCEPTED.
IF YOUR BLOWER WAS DAMAGED IN
TRANSIT, YOU MUST FILE A CLAIM
DIRECTLY WITH THE FREIGHT CARRIER.
LABCONCO CORPORATION AND ITS
DEALERS ARE NOT RESPONSIBLE FOR
SHIPPING DAMAGE.
Do not discard the packing material for your blower until you have
installed and tested the blower.
Install the Blower on a
Supporting Structure
Now that you have located your blower as instructed in Chapter 2:
Prerequisites, you are ready to mount the blower on a roof curb
support. Additionally, you may isolate the blower by mounting the
blower on either vibration isolators or vibration mounting pads,
which are available from a local industrial supply company. The
supporting structure is custom for each installation. Labconco
recommends supporting the blower with 5/16" diameter mounting
hardware. See Appendix B: Blower Dimensions for appropriate
mounting hole locations for your particular blower.
Adjust the Blower Outlet
Orientation
The housing on your blower can be rotated to facilitate your duct
run configuration. By rotating the blower housing, you will be
able to change the blower outlet location on your blower. The
Coated Steel Blowers can be rotated to one of eight different
positions and the Fiberglass or PVC Blowers can be rotated to one
of three different positions. See the drawings in Appendix A to
locate the parts to disassemble. To rotate the blower housing,
proceed as follows:
1. Remove the upper weathercover panel, which has louvers.
2. Once removed, you have complete access to the 8 fasteners
that hold your blower housing assembly in position.

