Owner manual

Product Service 1-800-522-7658
6
C
C
H
H
A
A
P
P
T
T
E
E
R
R
2
2
P
P
R
R
E
E
R
R
E
E
Q
Q
U
U
I
I
S
S
I
I
T
T
E
E
S
S
Before you install your Stoppering Tray Dryer, you need to prepare your site for
installation. The Stoppering Tray Dryer will mount on top of a FreeZone 6, 12 or
18 liter Freeze Dry System. This could be either a benchtop or console model.
Carefully examine the location where you intend to install your Stoppering Tray
Dryer. You must be certain that the area is level and of solid construction. An
electrical source must be located near the installation site.
Carefully read this chapter to learn:
 the electrical supply requirements.
 the vacuum pump requirements.
Refer to Appendix C: Stoppering Tray Dryer Specifications for complete
Stoppering Tray Dryer electrical and environmental conditions, specifications and
requirements.
Refer to the User’s Manual for the FreeZone Freeze Dry System for complete
electrical and environmental conditions, specifications and requirements.
Electrical Requirements
The Stoppering Tray Dryer requires a dedicated electrical outlet. This outlet
requires a 20 Amp circuit breaker or fuse for models rated at 115V (60 Hz). An
outlet equipped with a 15 Amp circuit breaker or fuse is required for models rated
at 230V (50/60 Hz). The power cord on 115V models is equipped with a 20 Amp
NEMA 5-20P plug. Various power cord configurations are provided with 230V
models. If this does not match with the available receptacle, remove this plug and
replace it with an approved plug of the suitable style.