Owner manual

Chapter 4: Using Your Stoppering Tray Dryer
Product Service 1-800-522-7658
21
Programming
The Tray Dryer will store up to five programs numbered 1 through 5. The five
programs, once programmed, will be retained in memory. To program a run,
select the program number that you want to use and enter the parameters as
follows.
Turn the Power switch to the ON position. Press the DISPLAY button until the
Auto LED lights.
NOTE: Values shown in this example are for reference only.
The “P” in the display will flash and the program number that will be run is
shown. To select different programs, press the UP or DOWN key to change
program number (Programs 1 through 5). When the desired program number is
displayed, press ENTER.
The display will show the parameters that were last entered for this program.
If any of the parameters are changed, the ENTER key must be pressed for the new
value to be stored. If the ENTER key is not pressed within 10 seconds after the
last parameter adjustment, the value will return to the previously stored value.
The flashing parameter name indicates the parameter that will be changed.
Pressing ENTER only will advance to the next parameter.
After the AUTO RUN cycle is started, segments with a value greater than the
segment running may have their parameters changed. Only the selected program
may be modified. To modify a different program, the system must be stopped and
the desired program selected.
Starting the Freeze Dry Cycle
After the desired cycles have been programmed, push the MODE button to
Select-AUTO. Push the RUN/STOP button to start the program running. The
RUN indicator will light. The System
P1 SEG 1 RAMP 00.0°C/MN
HOLD –34°C TIME 00.0