User Manual

Labconco Operating Instructions 5242600, Rev. B 4/27/07, ECO E275 5 of 20
Main Modes of Operation
The Labconco Glove Box Pressure Controller display has four main screens that provide access
to the 4 modes of operation listed below. The operation modes are covered in the next sections of
this document.
1.) Glove Box Pressure Control Mode
2.) Glove Box Purge and Fill Mode
3.) Transfer Chamber Purge and Fill Mode
4.) Setup Mode
Press the Mode key at the upper-left hand corner of the display screen to switch between each of
these four operation modes. Please be aware that if one of the glove box modes is
running/started, other glove box operation modes cannot be used. For example, if the Glove Box
Pressure Control mode has started (using the start key), the menu page for the Glove Box
Purge/Fill mode cannot be used – this prevents operational control conflicts from occurring at the
same time.
Manual
Purge
Manual
Fill
Start/Stop
Setup
Increase
Upper Limit
Decrease
Upper Limit
Mode Key
Mute/Alarm
Increase
Lower Limit
Decrease
Lower Limit