User guide


Maintenance
The cabinet is finished with stainless steel and to maintain appearance should be wiped over with a                
non abrasive cleanser. The chamber is manufactured from stainless steel and may be cleaned with              
a solvent and if grained stainless steel chamber a stainless steel scratch pad may be used. The                
padshouldberubbedinthesamedirectionasthegrainpatternofthestainlesssteel.
The silicone gasket should be cleaned with detergent only, ensuring it is dried completely after              
washing. To prolong life it may be stored at cool temperatures in a container of water. Gasket                
lubricantisavailabletoprovideprolongedlifeandbettersealingonthegasket.
The locking pins should be regularly greased with high temperature grease to reduce binding in the               
guides.

WARNING:THISAUTOCLAVESHOULDNEVERBECONNECTEDTOMAINSWATERSUPPLY


Troubleshooting



SYMPTOM
REMEDY
NoPower

(IndicatorLightisoff)






1. Check autoclave is plugged in and power     
switchedon.

2. Ensure mains power supply point is     
functioning by using a test appliance on      
powersocket.

3. CheckinternalRCDhasnottripped.


Failuretoheatormaintaintemperature

(Indicatorlightison)
1. Thetemperaturecontrollerison.

2. The water level is above the low water      
sensor and the low water indicating lamp     
isoff.


Thetimerdoesnotstart
1. Check the AL4 value is equal to set value       
asthisvalueactivatesthetimer.



If the fault cannot be found call your distributor or the manufacturer quoting the serial number of the                 
autoclavefromthemanufacturerslabel.



DeclarationofConformity
Each product is thoroughly inspected and tested to not only ensure that it meets the specifications               
provided, but to also meet Australian Electrical Standard AS3820 and EMC Standard           
AS/NZ1044:1995,and therefore being accredited with a C Tick label. Labec Autoclaves are           
constructed in accordance with Australian Standard 1210 and are approved by Workcover Authority            
ofNSWwithreciprocalapprovalbyequivalentbodiesinallstatesofAustralia.


LaboratoryEquipmentPtyLtdInstructionManualAutoclaveAA9BenchTopModel