IN STRUC TION MANUA L Laboratory Equipment Pty Ltd email: sales@labec.com.au Ph: 02 9560 2811 • Fax: 02 9560 6131 www.labec.com.
INSTRUCTION MANUAL FOR HOG-020/020D HOMOGENIZERS PLEASE READ THIS MANUAL CAREFULLY BEFORE OPERATION 3, Hagavish st. Israel 58817 Tel: 972 3 5595252, Fax: 972 3 5594529 mrc@mrclab.com MRC.VER.02-11.
Ⅰ、OUTLINE Speed adjuster (H2G- 0 only) Body Body chuck Holding screw Pole Head Stand base Controller (H2G- 0D only) Power switch Speed adjuster Ⅱ、SPECIFICATION Model H2G- 0 / H2G- 0D Power AC 110 / 220V , 50 / 60 Hz Motor AC 250W Max.
Ⅲ、OPERATION INTRODUCTION 1. Put container on stand base and keep distance between the head and bottom of container. 2. Turn the speed button to the end of left side. 3. Put plug into socket and then switch to be “ON” to start it. 4. Adjust speed button to be proper speed per your demand. 5. When you stop it, please turn speed button to the end of left side. 6. Switch the key to be “ OFF ”. Ⅳ、ATTENTION 1. Do not start it without any material inside container. 2.
Ⅵ、APPLICATION OF HEADS Model Applicable range *(1 To homogenize or mix on cell tissue in micro volume. 1. To disperse plant or animal tissue. *(1 2. To treat suspensions and emulsions. 3. Homogenizing and mixing. 4. Extraction function. 1. To disperse plant or animal tissue. *(1 2. To treat suspensions and emulsions. 3. Homogenizing and mixing. 4. Extraction function. 1. To disperse organic and inorganic matters. *(1 2. Homogenizing and mixing. 3. Extraction function.
TO OPEN AND SEPARATED *(1 Insult the tools into the shaft Turn the tools to open After open the shaft , 3 main parts from shaft *(1 as follows Connect pipe Shaft of connect pipe 4 Turning cutter
TO OPEN AND SEPARATED *(1 Insult the tools into the shaft Turn the tools to open After open the shaft , 7 main parts from shaft *(1 as follows Connect pipe Bearing Bolts E type washer Shaft of connect pipe 5 Pipe Turning Cutter
TO OPEN AND SEPARATED *(1 Insult the tools into the shaft Turn the tools to open After open the shaft , 8 main parts from shaft *(1 as follows Connect pipe Pipe Fixed cutter Shaft connect pipe Bearing Bolts E type 6washer Turning cutter
TO OPEN AND SEPARATED *(1 Insult the tools into the shaft Turn the tools to open After open the shaft , 8 main parts from shaft *(1 as follows Connect pipe Pipe Shaft connect pipe Bearing Bolts 7 E type washer Fixed cutter Turning cutter
TO ASSEMBLY *(1 Put each parts into Accordinly with the drawing Insult the tools into the shaft Turn the tools to fixed Turning cutter Shaft of connect pipe 8
TO ASSEMBLY *(1 Put each parts into Accordingly with the drawing Insult the tools into the shaft Turn the tools to fixed 9
TO ASSEMBLY *(1 Put each parts into Accordinly with the drawing Insult the tools into the shaft Turn the tools to fixed 10
TO ASSEMBLY *(1 Put each parts into Accordinly with the drawing Insult the tools into the shaft Turn the tools to fixed 11