Compatibility Guide
Table Of Contents
- Before completing settings
- Connection settings for connecting to computer
- Connecting from a portable terminal
- Adding a second computer or portable terminal
- Checking/changing the printer network settings
- Initializing the Network Settings
- Troubleshooting
- Troubleshooting issues with network settings made using the Label Editor installer
- Troubleshooting issues with network settings made using the Network Configuration Tool
- Troubleshooting issues with wireless LAN connections (Infrastructure Mode)
- Troubleshooting issues with wireless LAN connections (Simple AP Mode)
- Troubleshooting issues with wired LAN connections
- Methods for resolving issues with not being able to connect at all
- Trademarks/Notation
10
Before completing settings
If connecting a device other than a computer to the printer, follow the procedures in
Connecting from a portable terminal (p.64).
Important
You will need part or all of the information listed below if planning to congure wireless
LAN settings manually or wanting to use a xed IP address for the printer. Check with
your network administrator in advance. Getting everything ready in advance will allow
you to set up your network smoothly.
Information necessary for setting up a xed IP address
• IP address set for the printer
• Subnet mask
• Default gateway
Information necessary for conguring a wireless LAN manually
• SSID set to the access point
• Security authentication method for the wireless LAN set to the access point
• Encryption method for the wireless LAN set to the access point
• Pre-Shared Key (PSK) set to the access point
• WEP key set to the access point