Compatibility Guide
Table Of Contents
- Before completing settings
- Connection settings for connecting to computer
- Connecting from a portable terminal
- Adding a second computer or portable terminal
- Checking/changing the printer network settings
- Initializing the Network Settings
- Troubleshooting
- Troubleshooting issues with network settings made using the Label Editor installer
- Troubleshooting issues with network settings made using the Network Configuration Tool
- Troubleshooting issues with wireless LAN connections (Infrastructure Mode)
- Troubleshooting issues with wireless LAN connections (Simple AP Mode)
- Troubleshooting issues with wired LAN connections
- Methods for resolving issues with not being able to connect at all
- Trademarks/Notation
7
Before completing settings
Î
Automatic setup by using a button on the printer (p.40)
Î
Manual setup (get required printer information by printing network status) (p.48)
When connecting the printer to a smartphone or a tablet computer, go to the link below.
Î
Connecting from a portable terminal (p.64)
Important
• Up to four devices can be connected at the same time with connections using
Simple AP Mode. You will not be able to connect a fth or subsequent device if there
are already four devices connected.
• You will not be able to connect to any devices connected to units other than the
printer or to the Internet while connected to the printer. Your Internet connection
will be disconnected when you run this conguration.
• The security mode is xed to WPA2-PSK (AES).
Wired LAN connection
This method allows users to connect to the printer via a hub, router, or similar device using
a wired cable.
Î
Setup for a wired LAN connection (p.55)