Compatibility Guide
Table Of Contents
- Before completing settings
- Connection settings for connecting to computer
- Connecting from a portable terminal
- Adding a second computer or portable terminal
- Checking/changing the printer network settings
- Initializing the Network Settings
- Troubleshooting
- Troubleshooting issues with network settings made using the Label Editor installer
- Troubleshooting issues with network settings made using the Network Configuration Tool
- Troubleshooting issues with wireless LAN connections (Infrastructure Mode)
- Troubleshooting issues with wireless LAN connections (Simple AP Mode)
- Troubleshooting issues with wired LAN connections
- Methods for resolving issues with not being able to connect at all
- Trademarks/Notation
97
Troubleshooting
Troubleshooting issues with wireless LAN
connections (Infrastructure Mode)
Is the power for the network device (access point/broadband
router) turned on?
Check to make sure that the power on the network device is turned on. If the power is
already turned on, check to ensure that the network is not currently being used and then
turn the power o and back on again.
Are the printer and network device (access point/broadband
router) close enough to be within range of each other?
Are there any obstacles that could be interfering with the
signals?
Try moving the computer and network device closer together and removing any obstacles
that may be causing interference.
Are you using the equipment near the printer that emits
electromagnetic waves (such as a microwave oven or digital
cordless telephone) or a wireless device?
If you attempt to use the printer around devices that emit electromagnetic waves
or wireless devices, signals emitted by such devices may interfere with printer
communications, causing problems. Move the computer and network device (access
point/broadband router) away from any such problematic equipment.
Turn the printer power o and then back on again to reset it.
You may not be able to connect the printer and network device (access point/broadband
router) temporarily depending on the order in which you turned power on to the devices.
After turning power back on to the printer, wait around 1 min. and then check the
connection status.
Is the printer set to Infrastructure Mode?
Check the / lamp on the printer to make sure that it is illuminated. If it is turned o,
press the
button to switch the settings.