Owner's Manual
Table Of Contents
- 1 Introduction
- 2 Quick Start
- 2.1 Setting Up the Equipment
- 2.2 Gathering Supplies and Equipment
- 2.3 Preparing the Urocap NXT
- 2.4 Preparing the NXT Go Pump Hub
- 2.5 Preparing the Roam NXT
- 2.6 Preparing the UPP Puller NXT (Optional)
- 2.7 Setting Up Consumables and Preparing the Patient
- 3 How to Perform a Study
- 4 Synergy Software
- 5 Maintenance and Service
- 5.1 Cleaning and Disinfection
- 5.2 Preventive Maintenance
- 5.3 Verifying Calibration
- 5.4 Configuration
- 5.5 Computer Virus Protection
- 5.6 Disposing of Product After Use
- 5.7 Environmental Consideration of Waste Disposal
- 5.8 Backups
- 5.9 Troubleshooting Guide
- 6 Hardware
- 7 Appendix
Hardware
NXT Go Owner’s Manual, LBL-00145, MAN2030 99
6.4.1.1 NXT Go Pump Hub Indicator Lights
Table 11 indicates the different statuses for the NXT Go Pump Hub. The NXT Go Pump Hub
must be connected to the power supply to function.
Table 11: NXT Go Pump Hub Indicator Signals
6.5 NXT Go Carrying Case
Use the NXT Go Carrying case to transport the NXT Go components.
Place the NXT Go components into the carrying case. Refer to Figure 79 for the
placement of each component.
Figure 79: NXT Go Carrying Case
Close the lid and secure the two clasps prior to transporting.
LABORIE Logo status
indicator
Pump Status Arrow
NXT Go
Pump Hub
Blinking White: Firmware
upgrade is in progress
Blinking White: Firmware upgrade is
progress (Synchronized blinking with
Laborie Logo)
Solid White: Standard
Slow breathing green: System is ready
Fast breathing green: System is
pumping
Slow breathing amber: System is not
ready
NXT Go Pump Hub
Urocap NXT
Roam NXT
and PIM NXT
Power Supply and
Cables
NXT Go Infusion Hook
Beaker
Case Clasp
Status DRAFT Effective