Owner's Manual
Table Of Contents
- 1 Introduction
- 2 Quick Start
- 2.1 Setting Up the Equipment
- 2.2 Gathering Supplies and Equipment
- 2.3 Preparing the Urocap NXT
- 2.4 Preparing the NXT Go Pump Hub
- 2.5 Preparing the Roam NXT
- 2.6 Preparing the UPP Puller NXT (Optional)
- 2.7 Setting Up Consumables and Preparing the Patient
- 3 How to Perform a Study
- 4 Synergy Software
- 5 Maintenance and Service
- 5.1 Cleaning and Disinfection
- 5.2 Preventive Maintenance
- 5.3 Verifying Calibration
- 5.4 Configuration
- 5.5 Computer Virus Protection
- 5.6 Disposing of Product After Use
- 5.7 Environmental Consideration of Waste Disposal
- 5.8 Backups
- 5.9 Troubleshooting Guide
- 6 Hardware
- 7 Appendix
Hardware
NXT Go Owner’s Manual, LBL-00145, MAN2030 109
To disconnect the catheter from the PIM NXT, press down on the thumb tab and
gently pull the connector from the PIM NXT.
T-DOC catheters provide the option of an integrated infusion lumen that connects
to the LABORIE Infusion Pump Tubing. Each catheter connector contains a
SmartSense tag that allows the user to scan information into the Synergy software
facilitating consumable traceability.
The connectors are color coded as per industry standard (Figure 91)—blue(Pves),
red(Pabd), and yellow(Pura).
Figure 91: T-DOC NXT Catheters – Color Coding
The PIM NXT uses an equivalent color-coding strategy to allow the user to match
color coded transducers to catheters of the same color (Figure 92). The PIM NXT
features an additional green transducer channel that can be used for vesical,
abdominal, or urethral measurement.
Figure 92: PIM NXT Color Coded Transducer Channels
IMPORTANT: Place all required supplies on a table or tray for easy access when
preparing the patient for full Urodynamic testing. Refer to the Gathering Supplies and
Equipment section on page 15 for more information.
6.11 EMG Electrodes
The following EMG patches are required for the user to perform a Urology Urodynamic
study: Snap-on electrodes (ELE428) and cable (CAB1091, CAB1092, CAB1103, CAB1104).
For information on how to place the electrodes, refer to the Placing the EMG Patch
Electrodes section on page 29.
6.12 Commode
The Commode Chair (CHA181 or CHA171) and Funnel (CHA102) are required equipment for
performing a FreeFlow or Urology Urodynamic study. Further information on how to setup
the commode chair, funnel, and Urocap NXT, can be found in the Gathering Supplies and
Equipment section on Page 19.
Pves Transducer
Channel
Pabd Transducer
Channel
Pura Transducer
Channel
Pves, Pabd, and Pura
Capable Transducer Channel
Status DRAFT Effective