Owner's Manual
Table Of Contents
- 1 Introduction
- 2 Quick Start
- 2.1 Setting Up the Equipment
- 2.2 Gathering Supplies and Equipment
- 2.3 Preparing the Urocap NXT
- 2.4 Preparing the NXT Go Pump Hub
- 2.5 Preparing the Roam NXT
- 2.6 Preparing the UPP Puller NXT (Optional)
- 2.7 Setting Up Consumables and Preparing the Patient
- 3 How to Perform a Study
- 4 Synergy Software
- 5 Maintenance and Service
- 5.1 Cleaning and Disinfection
- 5.2 Preventive Maintenance
- 5.3 Verifying Calibration
- 5.4 Configuration
- 5.5 Computer Virus Protection
- 5.6 Disposing of Product After Use
- 5.7 Environmental Consideration of Waste Disposal
- 5.8 Backups
- 5.9 Troubleshooting Guide
- 6 Hardware
- 7 Appendix
Appendix
NXT Go Owner’s Manual, LBL-00145, MAN2030 121
100
11,70
11,70
23,30
For transmitters rated at a maximum output power not listed above, the recommended
separation distance d in meters(m) can be estimated using the equation applicable to the
frequency of the transmitter, where P is the maximum output power rating of the
transmitter in watts(W) according to the transmitter manufacturer.
Note 1: At 80 MHz and 800 MHz, the separation distance for the higher
frequency range applies.
Note 2: These guidelines may not apply in all situations. Electromagnetic
propagation is affected by absorption and reflection from structures, objects
and people.
Table 20: Separation Distances between Portable and Mobile RF
Communications Equipment and the NXT
Transmitter and Wireless Compliance Statements
This device complies with part 15 of the FCC Rules. This device contains licence-exempt
transmitter(s)/receiver(s) that comply with Innovation, Science, and Economic Development
Canada's licence-exempt RSS(s). Operation is subject to the following two conditions: (1)
This device may not cause interference. (2) This device must accept any interference,
including interference that may cause undesired operation of the device.
Cet appareil contient des émetteurs / récepteurs exemptés de licence qui sont conformes
aux RSS exemptes de licence d'Innovation, Sciences et Développement économique
Canada. Le fonctionnement est soumis aux deux conditions suivantes: (1) Cet appareil ne
doit pas causer d'interférences. (2) Cet appareil doit accepter toute interférence, y compris
celles susceptibles de provoquer un fonctionnement indésirable de l'appareil.
Note: This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in a residential
area is likely to cause harmful interference in which case the user will be required to correct
the interference at his own expense.
Status DRAFT Effective