Owner's Manual
Table Of Contents
- 1 Introduction
- 2 Quick Start
- 2.1 Setting Up the Equipment
- 2.2 Gathering Supplies and Equipment
- 2.3 Preparing the Urocap NXT
- 2.4 Preparing the NXT Go Pump Hub
- 2.5 Preparing the Roam NXT
- 2.6 Preparing the UPP Puller NXT (Optional)
- 2.7 Setting Up Consumables and Preparing the Patient
- 3 How to Perform a Study
- 4 Synergy Software
- 5 Maintenance and Service
- 5.1 Cleaning and Disinfection
- 5.2 Preventive Maintenance
- 5.3 Verifying Calibration
- 5.4 Configuration
- 5.5 Computer Virus Protection
- 5.6 Disposing of Product After Use
- 5.7 Environmental Consideration of Waste Disposal
- 5.8 Backups
- 5.9 Troubleshooting Guide
- 6 Hardware
- 7 Appendix
Quick Start
NXT Go Owner’s Manual, LBL-00145, MAN2030 19
Login to Synergy by inputting the account User Name and Password, assigned
during system install, into the Synergy Login Page. The Synergy Main Window will
load. Refer to Figure 33: Synergy Main Window Reading Guide. Ensure to update
access information from initial system install. Refer to the User Access Control
section on page 42 for more information on logging in to Synergy and accessing
controls.
2.2 Gathering Supplies and Equipment
Prior to beginning a Urodynamics study, the user should ensure that the following supplies
and equipment have been gathered and prepared for use during the procedure.
IMPORTANT: Place the required supplies on a table or tray for easy access when
preparing the patient for full Urodynamic testing.
Procedure Specific items:
Straight catheter
Catheterization supplies such as
cleansing swabs, lubricant, etc.
Saline bag
Exam gloves
Tape
Preparation tray
System Specific Items:
NXT Go Pump Hub (DCX2101)
NXT Go Infusion Hook (MSM1185)
Urocap NXT (UCX2001)
Remote Control NXT (RCX2001)
Roam NXT (ROX2001) & PIM NXT for T-
DOC (PIX2211)
Roam NXT (ROX2001) & PIM NXT for Fluid
(PIX2231)
Urocap NXT Stand with Funnel (MSM1172 &
CHA1000)
UPP Puller NXT (UPX2001) and UPP Stand
(UPP1006)
Status DRAFT Effective