Owner's Manual
Table Of Contents
- 1 Introduction
- 2 Quick Start
- 2.1 Setting Up the Equipment
- 2.2 Gathering Supplies and Equipment
- 2.3 Preparing the Urocap NXT
- 2.4 Preparing the NXT Go Pump Hub
- 2.5 Preparing the Roam NXT
- 2.6 Preparing the UPP Puller NXT (Optional)
- 2.7 Setting Up Consumables and Preparing the Patient
- 3 How to Perform a Study
- 4 Synergy Software
- 5 Maintenance and Service
- 5.1 Cleaning and Disinfection
- 5.2 Preventive Maintenance
- 5.3 Verifying Calibration
- 5.4 Configuration
- 5.5 Computer Virus Protection
- 5.6 Disposing of Product After Use
- 5.7 Environmental Consideration of Waste Disposal
- 5.8 Backups
- 5.9 Troubleshooting Guide
- 6 Hardware
- 7 Appendix
Quick Start
NXT Go Owner’s Manual, LBL-00145, MAN2030 21
UPP Puller NXT Cable (CAB1109)
USB to Binder Cable Adapter (CAB1117)
NXT Magnetic Pogo Pin Cable, Binder
Termination, 3m Length (CAB1081)
Power Supply, Medical Grade, Class II Wall
Plug (POW1033)
NXT Go Power Cord (POW006)
NXT Go USB Cable (CAB1056)
NXT Go Power Supply (POW1043)
Roam NXT Mounting Bracket (MSM1153)
NXT Go IV Pole Bracket (MSM1062)
NXT GO Carrying Case (PKG1091)
2.3 Preparing the Urocap NXT
To prepare the Urocap NXT for use:
Ensure that the Urocap NXT is charged and ready to use.
Place the funnel on the plastic frame of the commode
chair.
Carefully place the Urocap NXT transducer on the floor.
Place the graduated beaker on top of the transducer.
Place the commode chair and funnel over the Urocap NXT
and beaker.
Figure 2: Urocap NXT
Setup
NOTE: For setup instructions using the Urocap NXT Stand refer to MAN1000.
IMPORTANT: Ensure all preparation steps are completed before starting a study in
Synergy.
Status DRAFT Effective