Owner's Manual
Table Of Contents
- 1 Introduction
- 2 Quick Start
- 2.1 Setting Up the Equipment
- 2.2 Gathering Supplies and Equipment
- 2.3 Preparing the Urocap NXT
- 2.4 Preparing the NXT Go Pump Hub
- 2.5 Preparing the Roam NXT
- 2.6 Preparing the UPP Puller NXT (Optional)
- 2.7 Setting Up Consumables and Preparing the Patient
- 3 How to Perform a Study
- 4 Synergy Software
- 5 Maintenance and Service
- 5.1 Cleaning and Disinfection
- 5.2 Preventive Maintenance
- 5.3 Verifying Calibration
- 5.4 Configuration
- 5.5 Computer Virus Protection
- 5.6 Disposing of Product After Use
- 5.7 Environmental Consideration of Waste Disposal
- 5.8 Backups
- 5.9 Troubleshooting Guide
- 6 Hardware
- 7 Appendix
How to Perform a Study
NXT Go Owner’s Manual, LBL-00145, MAN2030 34
Figure 21: Post Voided Residual Window
Click OK on the Post Void Residual window to save data and advance to the
Report. Pressing Cancel skips the PVR window.
NOTE: Post Voided Residual may also be entered and edited in the Report.
3.2.2.3 FreeFlow Report
A preview of the FreeFlow Report will be generated using the default (UDS)
configuration settings (Figure 22). The user can apply the default configuration for
the report or customize the report. For information on customizing the report,
refer to the Reports section on page 65.
Figure 22: FreeFlow Preview Report
Click the Finish button. The report will appear under the Studies tab in the
Patient Details section.
The operator may begin a secondary test with the same patient, under the
guidance of the overseeing physician, or continue to Finish the Study.
NOTE: Reference the Finishing the Studies section on page 41 and the Printing the
Study Result (Optional) section on page 41 for instructions on completing the study.
Status DRAFT Effective