Owner's Manual
Table Of Contents
- 1 Introduction
- 2 Quick Start
- 2.1 Setting Up the Equipment
- 2.2 Gathering Supplies and Equipment
- 2.3 Preparing the Urocap NXT
- 2.4 Preparing the NXT Go Pump Hub
- 2.5 Preparing the Roam NXT
- 2.6 Preparing the UPP Puller NXT (Optional)
- 2.7 Setting Up Consumables and Preparing the Patient
- 3 How to Perform a Study
- 4 Synergy Software
- 5 Maintenance and Service
- 5.1 Cleaning and Disinfection
- 5.2 Preventive Maintenance
- 5.3 Verifying Calibration
- 5.4 Configuration
- 5.5 Computer Virus Protection
- 5.6 Disposing of Product After Use
- 5.7 Environmental Consideration of Waste Disposal
- 5.8 Backups
- 5.9 Troubleshooting Guide
- 6 Hardware
- 7 Appendix
Synergy Software
NXT Go Owner’s Manual, LBL-00145, MAN2030 55
4.4 Study Management
Workflows
Synergy Workflows control the structure and content of each study. Each Workflow has
standard Workflow Steps: Procedure, Questionnaire, Report, and Review. Workflows vary
by the phases contained in the default configuration of their Procedure workflow step.
Access Workflow settings in the Workflow Configurator window by navigating to Settings
> Workflow > Editor. The following workflow templates are available from the Workflow
Configurator window:
FreeFlow
o Two phase procedure for uroflowmetry
o Preview and Voiding
Flow-EMG
o Two phase procedure for uroflowmetry combined with EMG
o Preview and Voiding
Urology Urodynamics
o Five phase procedure for standard Urodynamics
o Preview, Voiding, Preview 2, Filling, Voiding
Urogynecology 2P Urodynamics
o Six phase procedure for Urodynamics with UPP using a single pressure bladder
catheter
o Preview, Voiding, Preview 2, Filling, Voiding, UPP
Urogynegology 3P Urodynamics
o Five phase procedure for Urodynamics using a single pressure bladder catheter
o Preview, Voiding, Preview 2, Filling, Voiding
Cystometry
o Two phase procedure for Urodynamics with a combined filling and voiding phase
called Cytometry
o Preview and Cystometry
The workflows described above reflect default workflow templates. Setup workflows to
appear under the New Studies, UDS tab on the Synergy Main window by creating copies
or customizations of the workflow templates. Refer to instructions provided in the
Customizing Workflows section on page 56.
To start a study, workflows must appear in the New Studies section of the Main Window.
UDS tab
Upon initial install Synergy will not show any workflows under the UDS tab. Studies are
added to the UDS tab once workflow templates are copied, customized, then saved in the
Workflow Configurator window.
Suggested tab
Studies are suggested based on patient file inputs such as patient symptoms and patient
history. Scientific references are available in the help menu of Synergy.
NOTE: Studies must be shown in the UDS tab to be suggested.
Status DRAFT Effective