Owner's Manual
Table Of Contents
- 1 Introduction
- 2 Quick Start
- 2.1 Setting Up the Equipment
- 2.2 Gathering Supplies and Equipment
- 2.3 Preparing the Urocap NXT
- 2.4 Preparing the NXT Go Pump Hub
- 2.5 Preparing the Roam NXT
- 2.6 Preparing the UPP Puller NXT (Optional)
- 2.7 Setting Up Consumables and Preparing the Patient
- 3 How to Perform a Study
- 4 Synergy Software
- 5 Maintenance and Service
- 5.1 Cleaning and Disinfection
- 5.2 Preventive Maintenance
- 5.3 Verifying Calibration
- 5.4 Configuration
- 5.5 Computer Virus Protection
- 5.6 Disposing of Product After Use
- 5.7 Environmental Consideration of Waste Disposal
- 5.8 Backups
- 5.9 Troubleshooting Guide
- 6 Hardware
- 7 Appendix
Synergy Software
NXT Go Owner’s Manual, LBL-00145, MAN2030 56
Customizing Workflows
The Workflow Configuration window has three main sections: Workflow drop down
menu, Workflow Steps, and Settings Tabs. To customize workflows or add workflows to
the UDS tab, begin by creating a copy of the workflow template.
Click Settings > Workflow > Editor in the title bar to launch the Workflow
Configuration window (Figure 43).
Figure 43: Workflow Configuration Window – Channels Tab
Select the workflow template to edit from the Workflow drop down menu and
click the Copy icon. This will unlock editing options for the Workflow Steps and
Settings Tabs.
Rename the workflow under the Workflow Name option.
NOTE: The name of the workflow, default or customized, will be shown on the header
of the study phases and on the final report.
Ensure that the Show workflow for New Studies option is selected. To add the
workflow to the UDS tab on the Synergy Main window click OK or continue
customization.
Configure custom workflows by completing the following steps:
Customize workflow step naming by selecting a step under Workflow Steps and
assigning a new name under Step Name if desired. Update Workflow Steps
layout by using the plus , up/down , and delete icons provided.
Select Procedure from under Workflow Steps. Customize Global, Channel,
Phase, and Event Summary settings by using the corresponding tabs available.
a. The Global settings tab provides settings standard across the default
workflows. These settings customize the view of the graph and its
channels during a study. Set preferences for features such as Urocap
Noise Reduction Level and Profile Settings.
i. Use the Urocap Noise Reduction Level feature to detect and
smooth chart spikes caused by environmental noise. Contact
LABORIE Service for guidance on option selection.
ii. Select UPP method, Manual Pull or Puller, using Profile Settings.
If using the Puller method ensure to set Puller Speed. To run a
UPP ensure a default workflow is selected that contains a UPP
phase, such as Urogynecology 2P Urodynamics or Urogynecology
Status DRAFT Effective