Owner's Manual
Table Of Contents
- 1 Introduction
- 2 Quick Start
- 2.1 Setting Up the Equipment
- 2.2 Gathering Supplies and Equipment
- 2.3 Preparing the Urocap NXT
- 2.4 Preparing the NXT Go Pump Hub
- 2.5 Preparing the Roam NXT
- 2.6 Preparing the UPP Puller NXT (Optional)
- 2.7 Setting Up Consumables and Preparing the Patient
- 3 How to Perform a Study
- 4 Synergy Software
- 5 Maintenance and Service
- 5.1 Cleaning and Disinfection
- 5.2 Preventive Maintenance
- 5.3 Verifying Calibration
- 5.4 Configuration
- 5.5 Computer Virus Protection
- 5.6 Disposing of Product After Use
- 5.7 Environmental Consideration of Waste Disposal
- 5.8 Backups
- 5.9 Troubleshooting Guide
- 6 Hardware
- 7 Appendix
Synergy Software
NXT Go Owner’s Manual, LBL-00145, MAN2030 60
To customize the appearance of buttons, click the Options icon located beside
the button. A window will appear where minor button functions and appearance
may be adjusted (Figure 47). Options include button caption, colors, and
connectivity. Once edits are complete click OK.
Figure 47: Edit Control Panel Button
Click the OK button located at the top of the Workflow Configuration window to
implement all changes to the custom workflow.
4.4.2.3 Accessing Hardware Channels
To access hardware channels, click the Settings icon in the title bar, and then click
Workflow > Editor. Select the required workflow then navigate to the Channels tab.
If hardware channels are not set correctly, a red exclamation point icon will appear on the
Channels tab as shown in Figure 48.
Figure 48: Workflow Configuration with Hardware Channel Error
To set hardware channels, first ensure to select the required Workflow option from the
Workflow dropdown menu. Click the Channels tab and confirm the presence of all desired
phases. Click the Set Default Hardware Channels button. Click the OK button to save
changes and proceed to start study.
Status DRAFT Effective