Owner's Manual
Table Of Contents
- 1 Introduction
- 2 Quick Start
- 2.1 Setting Up the Equipment
- 2.2 Gathering Supplies and Equipment
- 2.3 Preparing the Urocap NXT
- 2.4 Preparing the NXT Go Pump Hub
- 2.5 Preparing the Roam NXT
- 2.6 Preparing the UPP Puller NXT (Optional)
- 2.7 Setting Up Consumables and Preparing the Patient
- 3 How to Perform a Study
- 4 Synergy Software
- 5 Maintenance and Service
- 5.1 Cleaning and Disinfection
- 5.2 Preventive Maintenance
- 5.3 Verifying Calibration
- 5.4 Configuration
- 5.5 Computer Virus Protection
- 5.6 Disposing of Product After Use
- 5.7 Environmental Consideration of Waste Disposal
- 5.8 Backups
- 5.9 Troubleshooting Guide
- 6 Hardware
- 7 Appendix
Synergy Software
NXT Go Owner’s Manual, LBL-00145, MAN2030 68
4.5.4.4 Normal Values
Normal Values is a data field available for activation within report customization. The
Normal Values field is intended to provide an expected range of values for different events
which may occur during the study (Figure 57).
By default, the Normal Values field will be unchecked in the Configuration
Settings for the report.
To enable the Normal Values field,
a) Select the required configuration copy, and then expand the Report content
option by clicking the arrow beside the title: .
b) Click the checkbox beside the Normal Values field to enable this function.
c) To save the changes to the report, click the Apply Changes button.
Figure 57: Normal Values
4.5.4.5 Sending Reports to EMR
Open the report from the Patients section or from the Reports Workflow Step and click
the Send to EMR button on the report ribbon bar. This icon will only be visible if
the user has an EMR license enabled. When the Send to EMR button is clicked, Synergy
validates if the EMR service is running. If the service is running Synergy will send the
report to the EMR System. If the EMR service has stopped, Synergy will display a
notification message. All studies in Synergy can be sent to an EMR system if an EMR license
is enabled.
Synergy displays a progress indicator while waiting for acknowledgement from the EMR
system. Synergy will wait for 10 seconds, then display a message asking if the user wants
to continue waiting. This 10 second wait time is configurable and can be increased if
needed from Synergy application configuration file. After 60 seconds from the time the
report was sent to EMR, the process will timeout and show an Export Failed dialog if no
acknowledgement had been received from EMR system (Figure 58).
Status DRAFT Effective