Owner's Manual
Table Of Contents
- 1 Introduction
- 2 Quick Start
- 2.1 Setting Up the Equipment
- 2.2 Gathering Supplies and Equipment
- 2.3 Preparing the Urocap NXT
- 2.4 Preparing the NXT Go Pump Hub
- 2.5 Preparing the Roam NXT
- 2.6 Preparing the UPP Puller NXT (Optional)
- 2.7 Setting Up Consumables and Preparing the Patient
- 3 How to Perform a Study
- 4 Synergy Software
- 5 Maintenance and Service
- 5.1 Cleaning and Disinfection
- 5.2 Preventive Maintenance
- 5.3 Verifying Calibration
- 5.4 Configuration
- 5.5 Computer Virus Protection
- 5.6 Disposing of Product After Use
- 5.7 Environmental Consideration of Waste Disposal
- 5.8 Backups
- 5.9 Troubleshooting Guide
- 6 Hardware
- 7 Appendix
Maintenance and Service
NXT Go Owner’s Manual, LBL-00145, MAN2030 83
5.2.1.2 Caring for the Urocap NXT
Ensure the Urocap NXT cover is not displaced or stretched after completing the cleaning or
disinfection process.
If the cover of the Urocap NXT becomes displaced, gently apply pressure around
its circumference to ease the cover back into place.
If the device’s rubber feet are lost or damaged, contact LABORIE Service for a
replacement.
If the device’s vent plug is lost or damaged, contact LABORIE Service for a
replacement. Avoid moisture or fluids near this area until a replacement vent plug
is received.
5.2.1.3 Caring for the UPP Puller NXT
Inspect the UPP Puller NXT to ensure there are no signs of visible deterioration of the device
prior to using it for a Urodynamics Study.
If the device’s Catheter Guide or Catheter Clamp are lost or damaged, contact
LABORIE Service for a replacement.
If the UPP Puller Arm Clip is lost or damaged, contact LABORIE Service for a
replacement.
Status DRAFT Effective