Manualshelf

User's Manual

ManualsBrandsLabway ManualsElectronicsPCI SOUND CARD
11121314151617181920
MachOne EV1935 PCI Sound Card Configuration/Hardware
Page - 8
3.3. Application Installation “Media Rack”
3.3.1. Windows 95 (4.00.950B OSR2)
1. Please start up your Microsoft Windows 95 OSR2 operating system.
2. The “MachOne PCI Setup” windows will appear. Click on the first push button labeled
“R”. The Setup program will initialize.
3. The “Setup” dialog box will appear. Click on OK to accept the default directory
"C:\Audio" as the destination location of your new Audio Software or type the name
of a directory you prefer.
4. The next Setup window warns you about possible harm to your hearing. Please read
the text carefully, before using your headphones. Click on OK to proceed to the next
step.
5. The installation of your new application software has been completed successfully.
Click on OK to finish the installation process.
6. After you have installed the “Willow Pond Audio” application software, the "Media
Rack" program icon appears.
3.4. Trouble Shooting/FAQ
1. System does not detect the device upon reboot in
Windows 95/98 or NT4.0
Windows NT4.0 does not support Plug-and-Play feature. Thus, if you are using
Microsoft Windows NT4.0, you need to add the device manually by following the
steps in the Windows NT4.0 Driver Installation section.
However, if you are using Windows 95 or Windows 98 it is abnormal for the system not
to detect the device. Check if the card is properly installed in the PCI slot.
2. There is no sound after driver installation
• Check whether the speaker connector is in the proper Line/Speaker Out jack.
• If you are using powered speaker (non-passive speaker), check whether the speaker
is powered on, and the speaker volume control enabled.
• Check the five MachOne devices in Device Manager, Control Panel. If you have a
non-PnP device, such as an old network card, you might find an exclusion mark on
the conflicted MachOne device. Please consult the non-PnP device manual to
change the occupied resource.
3. How to control the volume if using passive speakers, which do not
support volume control on speakers
You need to install the Windows 95/98/NT4.0 volume control. To install,
3.1 Go to “Start” ⇒ “Settings” ⇒ “Control Panel”, and open the “Control Panel” window.
3.2 Double-click on the “Add/Remove Programs” icon.
3.3 In the “Add/Remove Programs” window, select the “Windows Setup” tab.
3.4 Highlight “Multimedia”, then click on the “Details …” button.
3.5 Select the “Volume Control” option. Click on OK.