User's Manual

MachOne EV1935 PCI Sound Card Configuration/Hardware
Page - 4
1.4.2. Internal Connectors:
J10: ........................Connector for CD-AUDIO IN. (ATAPI)
J11: ........................Connector for CD-AUDIO IN. (JST)
JP1:........................Jumper for switching between SPEAKER OUT/LINE OUT.
1.4.3. Audio Connectors:
.
J10: CD-Audio-In
L: LEFT CHANNEL SIGNAL
ATAPI
G: GROUND
R: RIGHT CHANNEL SIGNAL
J11: CD-Audio-In
L: LEFT CHANNEL SIGNAL
JST
G: GROUND
R: RIGHT CHANNEL SIGNAL
G L G R
L G G R
1.4.4. Audio Output Jumper Settings for JP1:
Audio Settting
SPEAKER OUT with
Power Amplifier (Default)
1
4
3
6
LINE OUT without
Power Amplifier
1
4
3
6
2. HARDWARE INSTALLATION
2.1. Before Installation
1.) Installing MachOne PCI PCI sound card is simple and straight forward.
However, if you are not familiar with your system, please consult your dealer
or computer manufacturer for assistance.
2.) Make sure Windows 95/98, or Windows NT4.0 is installed and functioning
properly
3.) No other sound device is plugged in and installed. If an other audio chip is
built-in with your system board, try to disable the built-in audio in the BIOS.