Operation Manual

INSTALLER’S MANUAL

【11】

Adjusting reduced ow of hob burners :

After connection or change of gas, it is crucial to modify this adjustment :

► Remove the knob.

► Light the appropriate burner.

► Adjust to minimum setting.

► Use a small screwdriver to set the adjusting screw J (fig.【11】).

N.B : Flame is reduced to  of its size in the minimum setting, the burner must remain lit when

changing from maximum setting to minimum setting.

Adjusting the safety devices for each thermocouple of the hob: :

If the burner goes out, having kept the control knob pushed in for roughly twenty seconds, check

that :

- The magnetic head grip the valve moderately.

- The flame touches the point of thermocouple (fig.【12】).

- The thermocouples and magnetic heads are absolutely clean.

【12】

Changing the oven gas type :

Oven injector :

► Remove the base.

CAUTION: when refitting place the base underneath the groove on the fascia (fig.【13】).

► Remove the drawer.

► Unscrew nut I from the injector holder with a size 7 wrench (fig.【14】).

CHANGE OF GAS

【13】

【14】

Ft 145a - GB - Rév 02 - Modifié le : 08/09/08 18/48

SAULIEU

SAVIGNY