Operation Manual

INSTALLER’S MANUAL

SITTING

2 We recommend the front edge of the hob be positioned 50 mm further forward than the adjacent

ttings. (see below).

1 If the adjacent parts contain heat-sensitive materials, ensure there is a 50-mm gap between the

side of the oven and the parts in question.

Ensure that the materials adjacent to the lateral panels of the oven are not

ammable.

Cautions :

The purchaser undertakes to install or arrange for his/her equipment to be installed in a workmanlike manner

and in accordance with the applicable regulations and standards.

Any servicing or repair work on appliance must be performed by a qualied technician.

Shipment-Packaging :

Carton packing crate on wooden palette

Unpack and check the appliance is in good condition. In case of damage, note any reservations on

the delivery note and confirm them within 48 hours by registered letter with confirmation of delivery

to the carrier.

◊ Recommendations :

→ Adjust this appliance by using the levelling feet. Allow a minimum clearance of 50 mm between

the appliance and any other surfaces (walls affected by heat).

→ If the appliance is to be built in between two surfaces, it is CRUCIAL to allow free circulation of

air behind the appliance (provide shielding at rear). Cooktops should NEVER be installed lower

than adjacent worksurfaces. It is also recommended to allow the unit front panel to protrude 50 mm

relative to the adjacent units.

→ Must be installed under an exhaust hood.

→ Do not install this unit near combustible walls, partitions, pieces of furniture or decorative

material unless these are covered with adequate thermal insulation of the noncombustible type.

Making sure the resulting installation meets local re regulations.

Ft 123a - GB - Rév 02 - Modifié le : 08/09/08 11/46

VOUGEOT

VOLNAY