Computer Drive User Manual

Setup Steps

I) Install an internal hard disk drive.

1. Make certain the power and USB 2.0 cables are disconnected from the LaCie box.

2. Turn the box over so that the rubber feet are pointing

up. Please note the two plastic bands for prying the

bottom plate from the top shell.

3. Open the casing by taking one plastic band in each

hand, between the thumb and index ﬁnger, and pull gently

until the bottom plate and the top shell have come apart.

4. Turn the enclosure

over, onto its rubber feet.

Remove the top shell and

safely place it within reach.

5. Gently slide the 3.5” SATA drive, label facing

up, onto the bottom plate until the SATA connector

plugs into the box’s internal SATA port. You will

feel the connection rather than hearing an audible

signiﬁcation.

6. Secure the disk drive in the casing by inserting the four screws

(included).