User manual

LaCinema Mini HD Bridge Introduction

User Manual page 11

1.5. Views of the LaCinema Mini HD

Bridge

1.5.1. Front View

1. Infrared receiver – Receives the infrared signal from the remote

control. Make sure the receiver is not obstructed.

Stand-by button – By default, pushing this button puts the drive

into stand-by mode or wakes it from standby (this behavior can

be modiﬁed; see 1.7. Power Management for more details)

2. Blue status light – If the drive is connected to a TV or computer,

this light will be on. It will turn off when disconnected.

3. USB port (connect disk) – Connect a USB disk, digital camera,

or card reader to access its multimedia ﬁles directly from your

TV.

1.5.2. Rear View

1. USB 2.0 device – Connect to your PC or Mac to copy ﬁles to the

LaCinema Mini HD Bridge’s internal storage

2. USB 2.0 host – Connect a USB disk, digital camera, or card

reader

3. Ethernet connector – Connect to your home network via an Eth-

ernet cable to your router

4. Optical audio out – Connect to digital home ampliﬁer

5. Video composite + stereo connector – Connect to any TV (CRT)

6. HDMI – Connect to a High Deﬁnition ﬂat screen TV or video

projector

7. Power connector – Must be connected when the drive is at-

tached to a TV. When connected to a computer, the drive is

bus powered through the USB connection, but if your computer

does not provide enough power through the USB port, connect

the power supply.

1.5.3. Internal

1. WiFi connection – Antenna is inside the product. Connect the

LaCinema Mini HD Bridge to a network via WiFi in order to

trans fer and play multimedia ﬁles.

CAUTION: Do not stack another electronic device on or below the

LaCinema Mini HD Bridge or place it in an enclosed area to avoid

performance and overheating issues (Fig. 06).

Fig. 04

Fig. 05

Fig. 06