Network Hardware User Manual

LaCie Network Space • DESIGN BY NEIL POULTON Setup
User Manual page 9
2.1. Turn the Drive On
The power supply kit is composed of two cables: one cable (A)
connects to the LaCie drive; and the other cable (B) connects to
a power outlet, such as a wall outlet or a surge protector.
1. Connect Cable A to the LaCie Network Space.
2. Connect Cable B to the power supply brick (C).
3. Connect Cable B to a surge protector or wall outlet.
4. Turn on the drive by moving the power switch on the back of
the drive to the “on” position.
The LaCie Network Space system may take up to 30 seconds to
boot up.
CAUTION: Only use the AC adapter supplied with your spe-
cific LaCie device. Do not use a power supply from another
LaCie device or another manufacturer. Using any other power
cable or power supply may cause damage to the device and
void your warranty.
Always remove the AC adapter before transporting your LaCie
drive. Failure to remove the adapter may result in damage to
your drive and will void your warranty.
TECHNICAL NOTE: You may use your LaCie drive when in a
foreign country thanks to its 100-240 Volt power supply. To be
able to use this feature, you may need to purchase an appro-
priate adapter or cord. LaCie accepts no responsibility for any
damage to the drive resulting from the use of an inappropriate
adapter. Using an adapter other than one authorized by LaCie
will void your warranty.
A
B
C