User Manual

18
ADJUSTMENTS
TO SQUARE THE CUTTING
WHEEL TO THE TABLE
Do not loosen any screws for this adjustment until
you have checked alignment with a square and
made a test cut to ensure that adjustments are
needed for your tile saw.
This saw has been adjusted at the factory to make
accurate cuts. However, should your tile saw need
adjustment after it has been unpacked and
assembled or due to machine wear, the following
steps will be used to align the table to the saw blade.
NOTE: Do not start any adjustment until you have
check alignment with a square and made a test cut
to ensure that adjustments are needed for your tile
saw.
Before performing any adjustments, make sure the tool is unplugged from the power supply and
the switch is in the OFF position. Failure to heed this warning could result in serious personal
injury.
• Unplug the saw.
• Remove upper splash tray (3).
• Use the provided Allen wrench to loosen hex
socket bolts (A) on the left rail.
• Place a framing square against the worktable
fence and flat part of the blade.
• Using Allen wrench to turn set screw (B) to adjust.
Move the rail until the fence is square with the
blade. (Set screws (B) are located on the outside
ends of left rail)
• Tighten the end hex socket bolts (A) to lock rail in
place. Then tighten remaining hex socket bolts (A).
FIGURE 30
FIGURE 31
FIGURE 32
A
FRAMING
SQUARE
B
A
A
19
TROUBLESHOOTING
For your safety, turn on/off switch to the OFF position and unplug the saw from the power source before
performing any of the trouble shooting steps below.
1. Motor is too hot:
• Tu rn off motor and let it cool down to room temperature
• Check and clean ventilation openings
• If the above actions do not fix the problem, call the Service Center at 1-800-850-2044.
2. Motor does not run:
• Verify that all electrical connections are secure
• Te st and reset the safety breaker on the power cord ground fault.
• Check that the power source is 120v AC
• If the above actions do not fix the problem, call the Service Center at 1-800-850-2044
3. Pump does not pump water to table:
• The water in the tray is not deep enough
• The water hose is loose or has come off at the pump
• The pump electrical cord is not firmly inserted into the intended receptacle
• The filter foam in the pump housing is dirty and/or blocked
4. Movement of the sliding tray is not smooth
• The rails are dirty and have build-up from use. Clean rails and guide rollers. Then lubricate them with spray
on water resistant lubricant.
Three Year Limited New Product Warranty
If within three (3) years from date of purchase, this product fails due to a defect in materials or Workmanship, call the Service
Center at 1-800-850-2044. Please have a copy of the original receipt for all warranty claims. This warranty excludes incidental
or consequential damages and failures due to misuse, abuse or normal wear and tear. This warranty gives you specific rights,
and you may also have other rights, which vary, from state to state. Please call 1-800-850-2044 for details.
To register your tool for warranty service visit our website at www.Lackmond.com.
REPLACEMENT PARTS
Use only identical replacement parts. You can order parts by calling Technical Service Manager at
1-800-850-2044 to receive personalized support from one of our highly-trained representatives.
free warning label replacement
If your warning labels become illegible or are missing, call 1-800-850-2044 for a free replacement.
18