User's Manual

OEM integration instructions:

This device is intended only for OEM integrators under the following conditions:

The antenna must be installed such that 20 cm is maintained between the antenna and users,

and the transmitter module may not be co-located with any other transmitter or antenna. The

module shall be only used with the external antenna(s) that has been originally tested and

certified with this module.

For all products market in US, OEM has to limit the operation channels in Channel 1 to Channel

11 or 3-9 as specified above by the supplied firmware programming tool. OEM shall not supply

any tool or info to the end-user regarding to Regulatory Domain change.

As long as 3 conditions above are met, further transmitter test will not be required. However, the

OEM integrator is still responsible for testing their end-product for any additional compliance

requirements required with this module installed (for example, digital device emissions, PC

peripheral requirements, etc.).

Important Notes:

The OEM integrator has to be aware not to provide information to the end user regarding how to

install or remove this RF module in the user's manual of the end product which integrates this

module. The end user manual shall include all required regulatory information/warning as show

in this manual.