Manual

28
SETUP
Attaching SimMan 3G Amputation or
Shotgun Arm
The Arm Adapter and Adapter Screw are designed to attach an
Amputation or Gunshot Arm to the Patient Simulator.
1 Fit the Arm Adapter into the hole in the arm bracket from inside
of the torso.
Note: Ensure that the flat edge of the adapter is facing the chest
hinge.
LA PULSES BP
LA CONV
BP
U
PU
PU
PU
L
A PULS
PU
A PU
2 The Adapter is now in place and the Trauma Arm can now be
connected with the Adapter Screw.
3 Thread the Adapter Screw through the Amputation Arm and
align the screw with the hole in the Arm Adapter.
4 Secure the Adapter with one hand from inside the torso. Screw
the Adapter Screw using the Phillips screwdriver.
Note: Tighten screw as desired to simulate more or less Arm Range
of Motion.
5 Connect the red tube from the Amputation Arm to the nearest
blood port on the torso.
Caution: Do not over rotate arm. Over rotating the arm may cause
the red vinyl tubing to disconnect.
Replacing SimMan 3G Left Leg with
Trauma Leg
1 Remove the SimMan 3G default leg. Open Torso Skin and
stomach foam as shown in Maintenance.
2 Unscrew hip joint connector. Remove the leg cables and tubes
from the connector.
3 Carefully remove the left leg with cables and tubes.
4 Insert the Amputation or Gunshot Leg with blood tube into the
leg socket.
5 Insert the blood tube into the side slot of the connector. Screw
the connector in place with one hand.
6 Connect the leg tube to the corresponding tube, as labelled
inside the torso.
7 Close the Stomach Foam and zip the Torso Skin back into place.