Installation and Assembly

ASSEMBLY INSTRUCTION

ASME A112.18.1 / CSA B125.1

1. Before Proceeding

We recommend calling a professional if you are

uncertain about installing this product! This product

should be installed in accordance with all local and

state plumbing and building code requirements.

2. Shut Off Water Supplies

Locate the water supply inlets and shut off both the

hot and cold water supply valves. If you are

replacing an existing faucet, remove the old faucet.

Clean the sink surface thoroughly in preparation for

the new faucet.

3. Secure New Faucet

Screw the bolts to the bottom of the faucet and

tighten with a Philips screwdriver. Position the

faucet on the sink. If the sink surface is uneven, a

small amount of silicone sealant may be needed.

Attach washers to the bolts and copper tubes.

Tighten the nuts to the bolts.

 Model 2041

 Designer Series

 3 Hole Installation

You may need:

For easy installation of your faucet

please:

 READ ALL the instructions,

warnings, care and maintenance

information before beginning

 Purchase the correct water supply

hook-up

4. Connect to Water Supplies (Hook-Ups Not

Provided)

Connect the hot and cold water supplies to the

shanks as shown.

PAGE 1
ASSEMBLY INSTRUCTION    ASME A112.18.1 / CSA B125.1 Model 2041 Designer Series 3 Hole Installation For easy installation of your faucet please:  READ ALL the instructions, warnings, care and maintenance information before beginning  Purchase the correct water supply hook-up You may need: 1.
PAGE 2
1. 2. Pop-Up Drain Installation Preparation Unscrew the top portion off the drain body and apply plumbers' tape on the top threaded end of the drain body. Secure Pop-Up to the Sink Insert the drain body from under the sink and screw the top portion onto the drain body. A small amount of silicone might be needed if the sink surface is uneven to seal top portion to sink. Tighten the mounting nut with a wrench, but do not over tighten. 3.
PAGE 3
CLEANING AND CARE Care should be given to the cleaning of this product. Although the finish is extremely durable, it can be damaged by harsh abrasives or polish. To clean, simply wipe gently with a damp cloth and blot dry with a soft towel. WARNING: SCRUBBING BUBBLES® BATHROOM CLEANER, LYSOL® BASIN TUB AND TILE CLEANER, and all other chemical cleaners must not be used on the faucet body and handle. Use of these cleaners can crack and/or severely damage the faucet.