Installation Guide

Variations in color due to weather, job conditions,
and method of application should be expected. To
correct color variation on stucco finishes (except
Santa Barbara Mission Finish) apply LaHabra Fog
Coat. To change the color of stucco finishes that
have not been painted or sealed (including Santa
Barbara Mission Finish) apply Allegro II Cement
Coating. Allegro II and Fog Coat are both available
in all of LaHabra’s Standard and Lifestyle colors.
During periods of hot or dry weather condition, a
light spray (mist) of clean water is recommended
over the stucco finish. LaHabra Exterior Stucco Color
Coat will normally dry and set the same day. Allow
28 days for curing.
Color and performance may be affected by the
addition of field additives. Field additives are not
to be used except at the direction of the Parex USA
Technical Support.
LIMITATIONS:
n Use only on surfaces that are sound, clean, dry,
unpainted, and free from any residue that might
affect the ability of this product to bond to the
surface.
n Exterior Stucco Color Coat is a finish material
installed at approximately 1/8” thick, it is not for
use as a stucco base material.
n Ambient and surface temperature must be 40° F
(4° C) or higher during application. Protect from
freezing for a period of not less than 48 hours
after set has occurred. Provide supplemental
heat and protection from precipitation as needed.
n Ambient and surface temperatures must not
exceed 120° F (49° C) during and 24 hours after
application.
n Application in direct sunlight in hot weather may
adversely affect aesthetics.
n Colors may vary due to substrate, weather, job
conditions and method of application. Before
applying product, a sample should be applied and
allowed to cure for color approval.
n Protect adjacent surfaces from overspray and
droppings, drips or spills. They should be removed
immediately with water or soap and water to
prevent the possibility of permanent staining.
n Always wear proper safety equipment, including
NIOSH particle mask, eye protection, and gloves
when mixing and applying this product.
WARNING:
n
Read complete Warning information printed
on product container prior to use. For medical
emergency information, call 1-800-424-9300.
n For more information on handling this product refer
to its Safety Data Sheet (SDS). The most current SDS
and Product Data Sheet (PDS) can be found on our
website.
n This Product Data Sheet has been prepared in
good faith on the basis of information available at
the time of publication. It is intended to provide
users with information about the guidelines for
the proper use and application of the covered
product(s) under normal environmental and
working conditions. Because each project is
different, Parex USA, Inc. cannot be responsible for
the consequences of variations in such conditions,
or for unforeseen conditions.
Parex USA, Inc., A California Corporation
4125 E. La Palma Ave., Suite 250
Anaheim, CA 92807
www.parexusa.com
866-516-0061 Tech Support: 800-226-2424
CI SOLUTIONS • STUCCO SYSTEMS • TILE AND STONE SYSTEMS
© Parex USA, Inc. March 2018 • LH ESCC DS 0318