Data Sheet

LWB5+
Datasheet
https://www.lairdconnect.com/ 39
© Copyright 2020 Laird Connectivity, Inc.
All Rights Reserved
Americas: [phone]
Europe: [phone]
Hong Kong: [phone]
 The LWB5+ modules are MSL level 4
R EGULATORY 
16.1 RegulatoryIDsSummary
Model US/FCC Canada/IC MIC
Sterling LWB5+ SQG-LWB5PLUS 3147A-LWB5PLUS 201-200402
16.2 CertifiedAntennas
The SQG-LWB5PLUS was tested with antennas listed in the following table. The OEM can choose a different manufacturer’s
antenna but must make sure it is of same type and that the gain is lesser than or equal to the antenna that is approved for use.
Manufacturer Model
Laird Connectivity
Part Number
Type Connector
Peak Gain
2.4GHz 5GHz
Laird Connectivity
2.4/5.5 GHz Dipole
Antenna
001-0009 Dipole RP-SMA 2dBi 2dBi
Laird Connectivity FlexPIFA 001-0021 PIFA MHF4L 2.5dBi 3dBi
Laird Connectivity Mini NanoBlade Flex EMF2449A1-10MH4L PCB Dipole MHF4L 2.78dBi 3.38dBi
Laird Connectivity Nanoblade ENB2449A1-10MH4L PCB Dipole MHF4L 2dBi 3.9dBi
ACX AD1608-A2455AAT/LF N/A
Chip
Antenna
MHF4L 1dBi 4dBi
Laird MHF4L Jumper
CARSMF10AMH4L-
001
N/A
SMA to
MHF4L
16.3 FCC
FederalCommunicationCommissionInterferenceStatement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one of the following measures:
 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and receiver.
 Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
 Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation.