Data Sheet

LWB5+
Datasheet
https://www.lairdconnect.com/ 41
© Copyright 2020 Laird Connectivity, Inc.
All Rights Reserved
Americas: [phone]
Europe: [phone]
Hong Kong: [phone]
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment
should be installed and operated with a minimum distance of 20 centimeters between the radiator and your body.
Label and Compliance Information
Product manufacturers must provide, with the finished product, a physical or e-label that states the following:
Contains FCC ID: SQG-LWB5PLUS
Information on Test Modes and Additional Testing Requirements
Test tool: wl tool shall be used to set the module to transmit continuously.
Additional Testing, Part 15 Subpart B Disclaimer
The module is only FCC authorized for the specific rule parts listed on the grant, and that the host product manufacturer is
responsible for compliance to any other FCC rules that apply to the host not covered by the modular transmitter grant of
certification. The final host product still requires Part 15 Subpart B compliance testing with the modular transmitter installed
16.4 ISEDCanada
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic
Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference
(2) This device must accept any interference, including interference that may cause undesired operation of the device
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et
Développement économique Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux
deux conditions suivantes :
(1) L’appareil ne doit pas produire de brouillage;
(2) L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le
fonctionnement.
This radio transmitter (IC: 3147A-LWB5PLUS) has been approved by Innovation, Science and Economic Development
Canada to operate with the antenna types listed below, with the maximum permissible gain indicated. Antenna types not
included in this list that have a gain greater than the maximum gain indicated for any type listed are strictly prohibited for use
with this device.
Le présent émetteur radio (IC: 3147A-LWB5PLUS) a été approuvé par Innovation, Sciences et Développement économique
Canada pour fonctionner avec les types d'antenne énumérés ci dessous et ayant un gain admissible maximal. Les types
d'antenne non inclus dans cette liste, et dont le gain est supérieur au gain maximal indiqué pour tout type figurant sur la liste,
sont strictement interdits pour l'exploitation de l'émetteur.
Manufacturer Model
Laird Connectivity
Part Number
Type Connector
Peak Gain
2.4GHz 5GHz
Laird 2.4/5.5 GHz Dipole Antenna 001-0009 Dipole RP-SMA 2dBi 2dBi
Laird FlexPIFA 001-0021 PIFA MHF4L 2.5dBi 3dBi
Laird Mini NanoBlade Flex EMF2449A1-10MH4L PCB Dipole MHF4L 2.78dBi 3.38dBi
Laird Nanoblade ENB2449A1-10MH4L PCB Dipole MHF4L 2dBi 3.9dBi
ACX AD1608-A2455AAT/LF N/A
Chip
Antenna
MHF4L 1dBi 4dBi
Laird MHF4L Jumper CARSMF10AMH4L-001 N/A SMA to MHF4L