Data Sheet

App Note Title
Application Note
https://www.lairdconnect.com/
6
© Copyright 2021 Laird Connectivity
All Rights Reserved
Americas: [phone]
Europe: [phone]
Hong Kong: [phone]
5.2 European Union (EU) – CE
The Lyra P modules are in conformity with the essential requirements and other relevant requirements of the Radio
Equipment Directive (RED) (2014/53/EU).
Please note that every application using the Lyra P module must perform the radio EMC tests on the end product, according
to EN 301 489-17.
It is ultimately the responsibility of the manufacturer to ensure the compliance of the end-product as a whole. The specific
product assembly may have an impact to RF radiated characteristics, and manufacturers should carefully consider RF
radiated testing with the end-product assembly.
A formal Declaration of Conformity (DoC) is available at the product web page which is reachable starting from
https://www.lairdconnect.com/.
5.3 USA - FCC
This device complies with FCC’s e-CFR Title 47, Part 15, Subpart C, Section 15.247 (and related relevant parts of the ANSI
C63.10.2013 standard) when operating with the embedded antenna or with the antenna type(s) listed in Table 43. Operation is
subject to the following two conditions:
 This device may not cause harmful interference, and
 This device must accept any interference received, including interference that may cause undesirable operation.
Any changes or modifications not expressly approved by Silicon Labs could void the user’s authority to operate the equipment.
FCC RF Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End users must follow
the specific operating instructions for satisfying RF exposure compliance.
This transmitter meets the mobile requirements at a distance of 20 cm and above from the human body, in accordance to the
limit(s) exposed in the RF Exposure Analysis.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter except in accordance
with FCC multi-transmitter product procedures.
OEM Responsibilities to Comply with FCC Regulations
This module has been tested for compliance to FCC Part 15.
OEM integrators are responsible for testing their end-product for any additional compliance requirements needed with this
module in- stalled (for example, digital device emissions, PC peripheral requirements, etc.). Additionally, investigative
measurements and spot checking are strongly recommended to verify that the full system compliance is maintained when the
module is integrated, in accordance with the Host Product Testing Guidance in FCC's KDB 996369 D04 Module Integration
Guide V01.
 General Considerations
This transmitter module is tested as a subsystem and its certification does not cover the FCC Part 15 Subpart B
(unintentional radiator) rule requirement. However, such requirement is typically applicable to the final host. Thus, the
final host will still need to be re- assessed for compliance to this portion of rule requirements, if applicable.
 Manual Information to the End User
The OEM integrator has to be aware not to provide information to the end-user regarding how to install or remove this
RF module in the user’s manual of the end product which integrates this module.
The end user manual shall include all required regulatory information/warnings as shown in this manual.
 OEM/Host Manufacturer Responsibilities
OEM/host manufacturers are ultimately responsible for the compliance of the host system.
This module must not be incorporated into any other radio device or system without retesting for compliance as multi-
radio and combined equipment.