User's Manual

LRM Radio Module –
Host Interface Specification
Registers
Document p/n: 9S02-7954-A001 Rev.A
Cattron-Theimeg Inc. Proprietary and Confidential Page 6-11
4xxMHz_UNITY_RC
4
418
-
434MHz, Compatible to Unity Radiocraft
-
based radios
450MHz_UNITY_ADL 5 450MHz, Compatible to ADL-based radios
450MHz_UNITY_CTRACK 6 450MHz, with Channel Tracking option (developed initially for UniversalStudios)
450MHz_SIAMNET
20
450MHz, for SIAMnet
800MHz_SIAMNET
21
800MHz, for SIAMnet
NO_MODE_DEFINED 255
6.5.2 RF Operation mode specific parameters
The available mode-specific parameters are listed in Appendix A
6.6 Section 7 Registers: Test commands and parameters
This section implements tests utilities that can be used for development, production and service.
Section 7: Test Commands and Parameters
-
Registers content after system re
set is zero
Addr
Type
Size
Access
Keyword
Description
Details
0xe0 UINT8 1 W test Test Mode
0xe4
UINT32
7
RW
testp
Test Parameters
6.6.1 Test modes
Several modes are defined. This list will expand as new modules and functionalities are developed. Note that not
all test modes are available in all LRM.
Test Mode value Definition
NO_TEST
0
Test mode disabled
TX_CW
1
Transmission of a un
-
modulated carrier (CW)
TX_1010 2 Transmission of a continuous stream of 1010…
TX_PRBS 3 Transmission of a continuous PRBS stream
TX_PACKETS_PRANDOM
4
Transmission of RF packets (10 packets/sec) with pseudorandom content
TX_PACKETS_PDEFINED
5
Transmission of RF packets (10 packets/sec) with pre
-
defined content
CALIB_IFCALIB 40 Calibration, Image Frequency Rejection
RX_IDLE 80 Radio in receive mode. Used mainly to allow reading the rssi.
RX_RSSI
81
Radio in receive mode; rssi is printed twice per second
RX_STATS
82
Radio in receive mode; rx packets statistics are printed once per second
RX_PACKETS 83 Radio in receive mode; rx packets content is printed once per second
RX_BER0 84 Bit Error Rate measurement test, given a continuous 1010… stream is received;
BER is printed periodically
RX_BER1
85
Same, except that BER is not printed; it has to be read using one
of the test parameter registers