User's Manual

Cattron Group International
2.2 Test Procedure Steps
2.2.1 Installation Verification
2.2.1.1 Ensure that all cables are secured and connected properly.
2.2.2 Power Verification
2.2.2.1 Power on the System
2.2.2.2 Check the power (Yellow LED) on the Transponder Reader. The LED
should be on continuously when 72VDC is supplied to the Reader.
2.2.3 Antenna Signal Verification
2.2.3.1 Check the (Green LED) antenna signal going to the Transponder Reader.
The LED should be on continuously to indicate that the 200Khz signal is
being received from the Transponder Antenna.
2.2.4 Test Transponder Verification
2.2.4.1 Check the (Red LED) antenna signal going to the Transponder Reader.
The LED should flash once every 15 seconds when 72VDC is supplied to
the Reader.
2.3 Troubleshooting Tips
2.3.1 Power Verification
2.3.1.1 If the power LED (Yellow LED) on the Transponder Reader is not lit,
verify first that all connection points for the power cable are secure.
2.3.1.2 Also, verify that the power termination points are connected to the MCC
terminal blocks.
2.3.2 Antenna Signal Verification
2.3.2.1 If the antenna signal LED (Green LED) on the Transponder Reader is not
lit, verify that all connection points for the antenna cable are secure.
3/6