User's Manual

01/2001, CATTRON - THEIMEG
TM
Page i
PENDANT STATION CONTROLLER
OPERATION & MAINTENANCE INSTRUCTIONS
IMPORTANT NOTICES
The security ‘i-Key’ that accompanies your Pendant Station (PS) controller has been pre-programmed
with certain system operating parameters before leaving our factory. If your PS controller is of the
Advanced Technology (AT) family that is custom built to your specification, such ‘i-Key’ parameters
will include a specific address and operating frequency. However, CATTRON-THEIMEG
™
strongly
advises you to check that our pre-configured address and frequency is not duplicated in other remote
control equipment located at, or around, your operating facility.
When returning an PSAT Pendant controller to CATTRON-THEIMEG
™
for repair, the original coded
‘i-Key’ supplied with the unit shall be returned with the unit.
When returning a PSEZ or PSCS Pendant controller to CATTRON-THEIMEG
™
for repair, we
recommend the coded ‘i-Key’ last used with the unit be returned with the unit.
Before returning a PSEZ or PSCS Pendant controller to CATTRON-THEIMEG
™
for repair, we
strongly recommend you record the operating address and frequency assigned to the controller as you
will be required to re-program these operating parameters after we return your controller. Refer to
Frequency and Address Reports in Section 5 of this manual for recording details.
When a PSEZ or PSCS Pendant controller is returned to CATTRON-THEIMEG
™
for repair, we make
every effort to establish the operating address and frequency assigned to your controller when it arrives
at our repair facility. Whenever such operands can be established, we will record the same on the
service documentation returned with your controller.
This equipment is firmware based. Any duplication of operating firmware without written consent of
CATTRON-THEIMEG
™
is prohibited. U.S. Copyright Laws protect all firmware, parts and product
listings, assembly files, and this manual.