User's Manual

01/2001, CATTRON

- THEIMEG

Section 4, Page 9

Top End Cap subassembly (Figures 4-3 and 4-3A), continued.

Replace the subassembly as follows (refer to Figure 4-3 above, unless stated otherwise):

Figure 4-3A. 2-pin and 6-pin connector orientation

NOTE: Orientation of the 2-pin and 6-pin connectors is critical in the following

step. If the 2-pin connector is reversed, the transmitter range will be

significantly reduced.

a. Connect 2 and 6-pin connectors (6 and 7) to their respective Transmitter and Encoder

Board sockets, observing orientation of connectors as shown in Figure 4-3A above.

b. Carefully align endcap sub-assembly (3) to controller (1) housing, taking care not to

pinch wiring harnesses (4 and 5).

c. Secure endcap sub-assembly (3) using five screws (2).

d. Replace Battery Pack. Refer to Replacement of Battery Pack, above.