User's Manual

Section 5, Page 2 01/2001, CATTRON

- THEIMEG

Installing Different PSCS (blue) & EZ (green) ‘i-Keys’, continued.

If you wish to continue remote control operations, it will be necessary to choose one of the following

options:

1. Install the original ‘i-Key’ into the controller,

or,

2. Re-program the address code and frequency of the controller with a different ‘i-

Key’ installed – refer to page 5 of this Section onwards for programming

procedures. This unique ‘i-Key’ serial number will then be registered with the host

controller’s programming software immediately upon entering one of the

controller’s keypad programming menu options.

NOTE. If option 2 above has been selected, inserting the original ‘i-Key’ (referred

to in option 1 above) or any other ‘i-Key’ into the controller will prevent

any further remote control operations.

PSEZ & CS Control Systems - frequency and address

assignment.

WARNING:

FAILURE TO PROPERLY SELECT FREQUENCY AND

ADDRESS MAY RESULT IN THE UNINTENTIONAL

OPERATION OF OTHER MACHINERY AND COULD RESULT

IN DEATH OR SERIOUS INJURY TO PERSONNEL. DO NOT

DUPLICATE ADDRESS ASSIGNMENT.

To enable a CATTRON-THEIMEG

™

PSEZ & PSCS controller and receiver/decoder to communicate,

they must use the same RF frequency and digital address. PSEZ PRC system controllers and

receiver/decoders are capable of operating on up to 79 different frequencies and 126 addresses. PSCS

PRC system controllers and receiver/decoders are capable of operating on up to 127 different

frequencies and 65,000 addresses for maximum versatility.