User's Manual

SaBLE-x Module
DATASHEET
The information in this document is subject to change without notice.
330-0166 Copyright © 2015 LSR Page 4 of 14
PIN DESCRIPTIONS
Module Pin Name I/O Type Description
1
RF OUT
RF
ANTENNA, 50 OHMS
2
GND
GND
GROUND
3
GND
GND
GROUND
4
NC
-
NO CONNECT (DO NOT CONNECT)
5
NC
-
NO CONNECT (DO NOT CONNECT)
6
/RESET
DI
ACTIVE LOW RESET. 100kΩ PULL-UP
7
JTAG TCKC
DI/DIO
JTAG TCKC
8
JTAG TMSC
DIO
JTAG TMSC
9
NC
-
NO CONNECT (DO NOT CONNECT)
10
NC
-
NO CONNECT (DO NOT CONNECT)
11
VCC
PI
POWER SUPPLY TO MODULE
12
VCC
PI
POWER SUPPLY TO MODULE
13
DIO 5/JTAG TDO
DIO
GPIO, JTAG TDO, ULP SENSOR INTERFACE, LED DRIVING CAPABILITY
14
DIO 6/JTAG TDI
DIO
GPIO, JTAG TDI, ULP SENSOR INTERFACE, LED DRIVING CAPABILITY
15
DIO 4
DIO
GPIO, LED DRIVING CAPABILITY
16
DIO 3
DIO
GPIO, LED DRIVING CAPABILITY
17
DIO 2
DIO
GPIO, ULP SENSOR INTERFACE, LED DRIVING CAPABILITY
18
DIO 1/BOOT RX
DIO
GPIO, ULP SENSOR INTERFACE, BOOTLOADER RX (UART0)
19
DIO 0/BOOT TX
DIO
GPIO, ULP SENSOR INTERFACE, BOOTLOADER TX (UART0)
20
DIO 7
DIO
GPIO, ANALOG INPUT, ULP SENSOR INTERFACE
21
DIO 8
DIO
GPIO, ANALOG INPUT, ULP SENSOR INTERFACE
22
GND
GND
GROUND
23
DIO 10
DIO
GPIO, ANALOG INPUT, ULP SENSOR INTERFACE
24
DIO 9
DIO
GPIO, ANALOG INPUT, ULP SENSOR INTERFACE
25
NC
-
NO CONNECT (DO NOT CONNECT)
26
NC
-
NO CONNECT (DO NOT CONNECT)
27
NC
-
NO CONNECT (DO NOT CONNECT)
28
NC
-
NO CONNECT (DO NOT CONNECT)
29
DIO 11
DIO
GPIO, ANALOG INPUT, ULP SENSOR INTERFACE
30
DIO 12
DIO
GPIO, ANALOG INPUT, ULP SENSOR INTERFACE
31
DIO 13
DIO
GPIO, ANALOG INPUT, ULP SENSOR INTERFACE
32
DIO 14
DIO
GPIO, ANALOG INPUT, ULP SENSOR INTERFACE
33
GND
GND
GROUND
34-39
GND
GND
GROUND AND THERMAL RELIEF PADS
PI = Power Input GND = Ground DI = Digital Input DO = Digital Output DIO = Digital Input/Output AI = Analog Input
RF = Bi-directional RF Port Note: See the Texas Instruments CC2640 datasheet and user guide for further details on the I/O.
Table 1 SaBLE-x Pin Descriptions