User's Manual

BT860
Datasheet
Embedded Wireless Solutions Support Center:
http://ews-support.lairdtech.com
www.lairdtech.com/bluetooth
34
© Copyright 2017 Laird. All Rights Reserved
Americas: [phone]
Europe: [phone]
Hong Kong: [phone]
18 B LUETOOTH SIG A PPROVALS
18.1. Application Note: Subsystem Combinations
This application note covers the procedure for generating a new Declaration ID for a Subsystem combination on
the Bluetooth SIG website. In the instance of subsystems, a member can combine two or more subsystems to
create a complete Bluetooth End Product solution.
Subsystem listings referenced as an example:
Design Name
Owner
Declaration ID
Link to listing on the SIG website
BT860-SA Laird B021369 https://www.bluetooth.org/tpg/QLI_viewQDL.cfm?qid=21369
Windows 8
(Host Subsystem)
Microsoft
Corporation
B012854 https://www.bluetooth.org/tpg/QLI_viewQDL.cfm?qid=12854
Laird Customer Declaration ID Procedure
This procedure assumes that the member is simply combining two subsystems to create a new design, without
any modification to the existing, qualified subsystems. This is achieved by using the Listing interface on the
Bluetooth SIG website. Error! Reference source not found. shows the basic subsystem combination of a
controller and host subsystem. The Controller provides the RF/BB/LM and HCI layers, with the Host providing
L2CAP, SDP, GAP, RFCOMM/SPP and any other specific protocols and profiles existing in the Host subsystem
listing. The design may also include a Profile Subsystem.
The controller provides the RF/BB/LM and HCI layers, with the Host providing L2CAP, SDP, GAP, RFCOMM/SPP
and any other specific protocols and profiles existing in the Host subsystem listing. The design may also include a
Profile Subsystem.
Figure 21: Basic subsystem combination of a controller and host subsystem
The Qualification Process requires each company to registered as a member of the Bluetooth SIG –
http://www.bluetooth.org
The following link provides a link to the Bluetooth Registration page: https://www.bluetooth.org/login/register/
For each Bluetooth Design it is necessary to purchase a Declaration ID. This can be done before starting the new
qualification, either through invoicing or credit card payment. The fees for the Declaration ID will depend on
your membership status, please refer to the following webpage:
https://www.bluetooth.org/en-us/test-qualification/qualification-overview/fees