User Manual

4.2.4 I/O Settings (See Figure 4-4)
The I/O page can be selected by clicking the I/O tab in the software. This is
shown in Figure 4-4. The I/O page can be used to setup select digital and
analog pins for desired operation.
Figure 4–4. I/O Settings
Digital I/O Configuration
• Input Output Level or Input Setup – Gives user ability to set selective
Port Pins for Output (0 or 1 Initial Value) or Input (With or Without
Internal Pull Up Resistor Enabled)
• Sleep Output Level or Input Setup - gives user the ability to configure
Digital I/O as desired for sleep state.
Digital I/O
• Output Value – User can select desired output value for any pin
configured as output
• Input Value – Tells user whether the input has a 1 or 0 applied to
selective pins configured as input (note pins configured as outputs
will register as 0)
Analog Inputs
• Readings – Displays analog input read by the micro
Sleep Analog State
• gives user the ability to configure I/O as desired for sleep state.
May be set to Digital Output 1 or 0 or the pins may remain set to
analog inputs.
Page 15 of 39