User Manual

Device 2 (Refer to Figures 4-8 and 4-9)
1. Set PAN ID to 100 (IDs Page)
2. Set short address to 2 (IDs Page)
*Note to use long addressing set short
address to 65,534
3. Disable Acknowledgements/Retries (RF Settings Page)
4. Disable Receive All RF Messages (RF Settings Page)
5. Set to RF Channel 23 (RF Settings Page)
6. Set transmitter power setting to 31 (RF Settings Page)
7. Set Short Destination address to 1 (Located Upper left corner of TT)
8. Select Short Address Radio Button(Upper Section of TT)
*Long may be selected if sending to a long address device
9. Select “Save Config To NV Memory” Command Button (Upper
Section of TT)
10. Check the Show Received box (Upper Section of Test Tool)
Figure 4-7 ID Settings for Device 1
Page 20 of 39