User Manual

20
4.2.6 Options (See Figure 4-4)
The Options page can be accessed by selecting the Options tab in the
software, and is shown in Figure 4-4. The following features are provided in
the Options page.
Host Serial Baudrate
• Allows the user to change the serial baudrate to be either 1.2k, 2.4k,
4.8k, 9.6k, 19.2k, 38.4k, 57.6k, or 115.2k.
• After clicking on “Set Interface Parameters” the module will send
back a host acknowledgement, save the new baudrate setting to
non-volatile memory, and perform a software reset.
• After changing the host serial baudrate it will be necessary to change
the baudrate that the test tool uses to communicate with the module
as described in Section 4-2.
• Set Interface Parameters – Sets Host Serial Baudrate.
• Get Interface Parameters – Gets Host Serial Baudrate.
Radio Features and Options
• PA Mode – Enables or disable the external 10mW or 100mW power
amplifier (depending on version of the module). Select 1mW to
disable the external power amplifier and 10mW/100mW to enable
the external power amplifier.
• Set Radio Features and Options* – Sets the PA Mode.
• Get Radio Features and Options – Gets the PA Mode.
* To permanently save select the “Save Config to NV Memory” command button.