User Manual

22
4.2.7 I/O Configuration (See Figure 4-5)
The I/O Configuration page can be accessed by clicking the I/O Config tab in
the software, and is shown in Figure 4-5. The I/O Configuration page can be
used to configure select I/O pins for digital or analog operation. Refer to
Table 4-2 for information on the I/O pin capabilities.
Figure 4-5. Digital I/O Configuration
I/O Configuration
• Initial Output Level or Input Setup – Gives user the ability to set
selective port pins for Output (0 or 1 Initial Value), Predefined LED
Functionality (L), Analog Input (A), or Input with or without internal
pull-up or pull-down resistor enabled.
• Sleep Output Level or Input Setup - Gives user the ability to
configure I/O pin states as desired for sleep operation. If Unchanged
(U) is selected then the particular pin(s) retain their state when sleep
operation is selected.