User Manual

4.2.8 Analog Configuration (See Figure 4-6)

The Analog Configuration page can be accessed by clicking the Analog

Config tab in the software, and is shown in Figure 4-6. The Analog

Configuration page can be used to configure the pins set as analog inputs

(Refer to Section 4.2.7) for their analog-to-digital converter settings.

Figure 4-6. Analog Input Configuration

Analog Input ADC Settings

• Reference Voltage – Gives user the ability to select the voltage

reference that will be used for the conversion. Options consist of the

AVDD_SOC supply voltage, the internal 1.25v reference, a voltage

applied to analog input pin 7 (P0_7), or the differential voltage

applied between analog input pins 6 and 7 (P0_6 and P0_7).

• Conversion Resolution - Gives user the ability to select the resolution

of the conversion. Options consist of 8, 10, 12 or 14 bits of

resolution, and the conversion takes longer as the resolution of the

conversion increases.

• Readings To Average – Gives user the ability to select the number of

ADC converter readings to average before returning a result.

Options consist of 1, 2, or 4 readings to average.