User Manual

49
OEM Responsibility to the FCC Rules and Regulations
The Matrix 10mW Module has been certified per FCC Part 15 rules for integration into products without
further testing or certification. To fulfill the FCC certification requirements the OEM of the Matrix 10mW
Module must ensure that the information provided on the Matrix 10mW Module label is placed on the
outside of the final product.
The Matrix 10mW Module is labeled with its own FCC ID Number. If the FCC ID is not visible when the
module is installed inside another device, then the outside of the device into which the module is installed
must also display a label referring to the enclosed module. This exterior label can use wording such as the
following:
“Contains Transmitter Module FCC ID: TFB-MATRIXLP”
or
“Contains FCC ID: TFB-MATRIXLP”
The OEM of the Matrix 10mW Module must only use the approved antenna, which has been certified with
this module.
The OEM of the Matrix 10mW Module must test their final product configuration to comply with
Unintentional Radiator Limits before declaring FCC compliance per Part 15 of the FCC rules.
Industry Canada Statement per Section 4.0 of RSP-100
The term "IC:" before the certification / registration number only signifies that the Industry Canada
technical specifications were met.
Section 7.1.5 of RSS-GEN
Operation is subject to the following two conditions:
1) this device may not cause harmful interference, and
2) this device must accept any interference received,
including interference that may cause undesired operation.
________________________________________________________________________
Section 2.6 of RSS-102
This portable transmitter with its antenna complies with Industry Canada RF Exposure Limits for
General Population/Uncontrolled Exposure.